DESK EDGE TWO PIECE CLAMP (standard mount for the Super 60 LCD Monitor Arm)

The design of this mount allows it to be affixed securely to a work surface edge. It mounts to tables as thin as 1" and as thick as 2". The mount requires a minimum lip width of 1.25" of distance from skirt. If you suspect that your desk or work surface material is not strong enough, you can add a spacer or piece of wood that displaces pressure over a wider area. This clamp mount is designed for the monitor center of gravity to stay over the work surface only.
Call 888 420 3200 for further explanation.

THROUGH-DESK GROMMET MOUNT

This mount affixes the LCD monitor arm to the top of desk or work surface through a grommet hole. This monitor arm mounts through grommet holes 5/16" to 5" in diameter. This style of mount is extremely secure and is recommended wherever there is a possibility that the LCD monitor arm may end up hanging off the back edge of the table.

Mounts to tables as thin as 1" and as thick as 2". Call us at 888 420 3200 if you require further explanation.

WALL MOUNT

This mount attaches to a wall behind the work center and allows the monitor arm to swivel slightly more than 180° when attached to a wall and even more if the mount is attached to a post or vertical standard.

WARNING: Wall mounts must be fastened securely into the wall, preferably into a stud. Do not fasten directly into sheet rock, plaster or dry wall. Work with a contractor or consult your local hardware store if you have any questions on what fastener is appropriate for your wall surface. Mounting hardware and method of attachment are the sole responsibility of the installer.