Clamp Mount Variation 1

With the typical clamp mount configuration, the clamp can fit desks up to 2.5" thick. If a table skirt or other obstruction runs along the underside of the surface, it must be 2" or greater from the table edge.

By inverting the smaller L bracket, the clamp will attach to surfaces up to 3.87" thick.

Clamp Mount Variation 3

The small L bracket can be repositioned if an obstruction runs along the underside of the surface between 1.25" and 2" from the surface edge. WARNING - The arm should not be allowed to rotate out behind the surface as the clamp is not completely stable in this configuration.

Clamp Mount Top View

The clamp mount extends 5.25" out on top of the surface and extends 6" across it.

Through-Desk

This configuration allows the arm to be attached to a desk with a hole that is 3/8" in diameter or slightly larger. Using this mounting configuration allows the user to precisely place the LCD monitor anywhere on a surface by simply drilling a small hole.

Thru Desk Top View

Wall Mount

This configuration illustrates the wall mount in the standard arrangement.

This configuration illustrates the reverse wall mount. This mount is frequently used at the tops of table legs where clamping is inappropriate.