Talk to an ergo expert: (888) 420-3200 or Email Us
EC-TRACK CPU HOLDERS
The Small CPU Holder can be adjusted to accommodate CPUs that are 2" to 3.5" wide.
The Medium CPU Holder is designed for CPUs from 3" to 5" in width.
The Large CPU Holder works with CPUs ranging from 4" to 6.25" wide.
The Extra Large CPU Holder can be adjusted between 5" to 8.25", making it possible to install a very large CPU, or even a CPU and a second device (e.g. UPS) side by side.
The regular Thin Client CPU Holder is for devices that are 1.12" to 1.88" wide. There are two versions. In both versions, the backplate can attach to an EC-TRACK Rail, an Ergomart tilter mechanism, a pole, or directly to the wall. The difference is in the front plate: the version on the right allows a VESA compatible monitor to be attached using the 75 x 75 mm or 100 x 100 mm VESA hole patterns or by means of an additional sliding VESA plate that can be installed along the vertical slot.
The large Thin Client CPU Holder is for slightly larger devices that are 1.62" to 3" wide. The mounting options are the same as the regular version. It can attach to an EC-TRACK Rail, a pole, a tilter head, or simply directly to a vertical surface. The front plate comes in two versions: a plain version or one that is intended to attach to a VESA compatible device, either directly, or using an additional sliding VESA adaptor.
The CPU Holder can be mounted anywhere along the EC-TRACK rail, allowing for the CPU to be placed where is best suited for the system set-up. The CPU Holder comes as an option with the EC-EZ1 and EC-EZ2 Complete Kits but can be added to any custom system by purchasing the CPU Holder with an MKIT-F.
Track-mounted Thin Client Holders with a VESA compatible front plate can be used as a kit for efficiently mounting a thin client CPU and a monitor so as to save vertical track space. In this configuration, the thin client is sandwiched between the track and the monitor and does not require additional track space. The basic VESA compatible Thin Client Holder seen in this picture comes with a front plate with 75 x 75 mm and 100 x 100 mm VESA holes for mounting the monitor at a preset height with respect to the thin client.
The vertical central slot on the Thin Client Holder permits additional adjustment of the relative vertical positioning of the monitor and thin client. The VESASL75 and VESASL100 Thin Client Holders come with additional slider plates with 75 x 75 mm or 100 x 100 mm VESA holes. These plates have centrally located holes for mounting to the vertical slot on the Thin Client Holder front plate shown in the image. This configuration allows the thin client to be vertically offset with respect to the monitor.