Talk to an ergo expert: (888) 420-3200 or Email Us
Our Mounting Kit L is for mounting two arms to one mount.
The mount itself clamps to horizontal surfaces up to 2" thick.
Mounting Kit L can be used as a desk clamp, thru desk, grommet hole and box edge mount.
Compatible arm models: SAA7000, SAA2010, SAA2045, SAA179, SAA2718, SAA2415, SAA4228, SAA4229.
From the wall to the very front of the Mount Kit L is 3.38 inches.
If a table skirt or other obstruction runs along the underside of the surface, it must be 2.75 inches or greater from the table edge using this configuration.
The small L bracket can be repositioned so that if a table skirt or other obstruction runs along the underside of the surface and is as close as 1.12 inches from the surface edge, the clamp can still be affixed to the edge. WARNING: The arm should not be allowed to rotate out behind the surface as the clamp is not completely stable.
This large VESA bracket is intended for mounting a monitor or TV with a 200x200 mm, 100x200 mm, or 120x180 mm hole pattern. The central hole patterns are 50x50 mm, 75x75 mm, and 100x100 mm, enabling this bracket to attach to the mounting location (e.g. an Ergomart Tilter Head) using a VESA 75/100 adaptor.
The large 200x400 mm VESA adaptor plate supports 50 mm, 75 mm, 100 mm and 200 mm square patterns, as well as 100x200 mm, 120x180 mm, 200x300 mm and 200x400 mm rectangular patterns. In some cases an additional 75 or 100 mm VESA adaptor is needed to interface the 200 x 400 mm VESA plate to the mounting location.
This VESA 1/4-Inch Spacer Kit allows monitors with VESA hole locations that are recessed by 1/4" or less to be attached to an Ergomart VESA plate.
This VESA 1/2-Inch Spacer Kit allows monitors with VESA hole locations that are recessed by 1/2" or less to be attached to an Ergomart VESA plate.