Typically, no, our mounts are designed specifically for Ergomart products. Contact Ergomart to determine if you would like assistance.
Talk to an ergo expert: (888) 420-3200 or Email Us
MKIT-N glides along the length of the RT Track with virtually no resistance.
The Kit N Track Mount is solely designed to affix to the horizontally mounted Heavy-Duty RT wall track.
Mounted monitor arms and equipment can be moved effortlessly along a horizontal Roller RT track can be custom ordered in lengths of up to 21 feet.
18 sturdy roller bearings allow heavy loads to be moved quietly for years of trouble-free use.
Mount Kit N will accept pole arms such as the LS9137 when purchased with shaft collars. This configuration allows for placement of peripherals above and below the mount.
Mounting Kit N is a sturdy and practical design that adds movement to mounted components and entire workstations.
This large VESA bracket is intended for mounting a monitor or TV with a 200x200 mm, 100x200 mm, or 120x180 mm hole pattern. The central hole patterns are 50x50 mm, 75x75 mm, and 100x100 mm, enabling this bracket to attach to the mounting location (e.g. an Ergomart Tilter Head) using a VESA 75/100 adaptor.
The large 200x400 mm VESA adaptor plate supports 50 mm, 75 mm, 100 mm and 200 mm square patterns, as well as 100x200 mm, 120x180 mm, 200x300 mm and 200x400 mm rectangular patterns. In some cases an additional 75 or 100 mm VESA adaptor is needed to interface the 200 x 400 mm VESA plate to the mounting location.
This VESA 1/4-Inch Spacer Kit allows monitors with VESA hole locations that are recessed by 1/4" or less to be attached to an Ergomart VESA plate.
This VESA 1/2-Inch Spacer Kit allows monitors with VESA hole locations that are recessed by 1/2" or less to be attached to an Ergomart VESA plate.
Typically, no, our mounts are designed specifically for Ergomart products. Contact Ergomart to determine if you would like assistance.
No and Yes. Since the tilter head pin is a smaller size than the arm pin, you would not be able to do that without installing an adapter bushing into the mount. Contact Ergomart if you wish to purchase the adapter.
They do not lock but in general stay in place unless the track is not installed level. These are meant for devices and monitors that need to be moved easily.
Yes, our Trolley MKit-N does have ball bearings for smooth sliding along the track.
There currently isn't a way to "lock" the mount in place, but we do offer a way to limit it's travel through the use of roller track trolley stops.