The Wall-Mounted Track with Sliding Data Entry Arm features an articulating monitor arm fitted with both a monitor and keyboard tray mount that is affixed to a heavy-duty rail, ideal for office, medical, technical and light industrial environments.
Below is a breakdown of the components of the Monitor and Keyboard Mount, highlighting the capabilities, similarities and differences of each component. If you have any questions or require more information, please don’t hesitate to get in touch with an Ergomart representative.
If you are looking for simply a monitor mount without a keyboard tray, the Wall-Mounted Roller Track with Articulating Monitor Arm provides excellent adjustment as an articulating monitor arm. The Low Profile Articulating Roller Track Monitor Mount features a compact monitor mount that sits close to the track.
The Wall-Mounted Track with Sliding Data Entry Arm is part of an entire family of modular mounts that can be assembled to meet almost any need. Our team at Ergomart is always ready to help you design a system that works for your requirements.
|Box 1 Monitor/Keyboard Arm Mount)||Box 2 (39-inch Track)||Box 2 (78-inch Track)|
|Shipping Weight||22 lbs||14.5 lbs (add 2.4 lb for optional wire manager)||24.2 lbs (add 4.7 lb for optional wire manager)|
|Shipping Dimensions||26" x 18" x 12"||41" x 7" x 7"||80" x 7" x 7"|
|Warranty||5 year limited|
The track-mounted monitor and keyboard tray arm shown in lowest position.
The data entry arm reaches forward 16.2 inches in its highest position and 16.1 in its lowest, from the center of the mounting pin to the back of the monitor backbar. When completely horizontal, the arm reaches approximately 20 inches. The total vertical range is 17.6 inches.
When the arm and tray are completely folded, the unit extends as little as 8.6 inches from the wall.
The monitor mounting VESA adaptor bracket can be adjusted by 6.7 inches along the vertical slot in the back bar, allowing the user to configure the distance between the monitor and keyboard tray.
The monitor/keyboard backbar can be mounted on the data entry arm at one of three heights set in 1.9-inch increments. Depending on the mounting position, the vertical range for attaching the VESA monitor mounting plate may be restricted.
The US made aluminum anodized RT Rail is the foundation of the Roller Track system. It can be mounted on the wall, vertical struts, or poles and accepts movable or stationary mounts that support the desired equipment. Each rail includes 2 end caps and 2 stops. The rail is not pre-drilled for fasteners and is designed to be drilled to accommodate on-site installation.
The Roller Track is available in three standard lengths of 39", 78", and 156" and comes in anodized metallic gray as a standard color with anodized black available as an option. It can be cut down after purchase to shorter lengths during installation.
Since the ends of the Roller Track are drilled and tapped, an end that is shortened on-site will require re-tapping or modification to ensure the end stop functions properly.
The J Channel chase is wide and deep enough to contain small power supplies and routers as well as various adapters. The units come without holes so that placement of holes can be determined by the installer; typically corresponding to the studs on either 16" or 24" centers.
This channel length is easily altered in the field during installation with a fine-toothed saw.
The J Channel dimensions are 5.36" x 1.92" and provide an effective cable storage cross section of 4.43" x 1.71".
This VESA 1/4-Inch Spacer Kit allows monitors with VESA hole locations that are recessed by 1/4" or less to be attached to an Ergomart VESA plate.
This VESA 1/2-Inch Spacer Kit allows monitors with VESA hole locations that are recessed by 1/2" or less to be attached to an Ergomart VESA plate.