Typically, no, our mounts are designed specifically for Ergomart products. Contact Ergomart to determine if you would like assistance.
Talk to an ergo expert: (888) 420-3200 or Email Us
The Universal Mount Kit R features a 1.5" x 2.75" hole pattern that allows users to create custom and adapted interface solutions when mounted to vertical surfaces.
It is cast from aluminum and machined for compatibility with most Ergomart monitor mounting arms.
It accepts four ¼"-20 machine screws to a maximum depth of .75 inches.
Compatible arms include: SAA7000,
SAA2010,
SAA2045,
SAA179,
SAA2718,
SAA2415,
SAA4229,
CMD2018,
CMD2415 and
CMT2415.
Compatible Monitor and Keyboard arms include: TRS7000AKP, TRS7000, TRS2718, TRS2018 and TRS2818D and others.
Contact us by phone or email with questions or requirements.
Four .45 diameter bosses extend past back plane of the MKIT-R They protrude 0.15 inches and are understood by viewing the Top, Side and Rear Views. These four fastener points each accept a 1/4-20 thread machine screw and are tapped to a depth of 0.5 inches.
Typically, no, our mounts are designed specifically for Ergomart products. Contact Ergomart to determine if you would like assistance.
No and Yes. Since the tilter head pin is a smaller size than the arm pin, you would not be able to do that without installing an adapter bushing into the mount. Contact Ergomart if you wish to purchase the adapter.
Fasteners are not included. Since Mount Kit R is attached from the back and accepts 4) 1/4-20 Machine screws to a depth up to .6" inches, it is up to the specifier or installer to determine the appropriate length screw.
Several details differentiate Mount Kit R. Unlike most other "wall mounts" it must be mounted from behind the surface to which it is attached. The four "nub" are technically referred to as bosses and each boss accepts a 1/4-20 machine screw to a depth of about 1/2". Since the mount is mounted from the back the visual effect is very clean since no screw heads or nuts will be visible.